How do I connect my monoblock kitchen taps to my pipework? - monoblock kitchen taps
I bought a new monobloc mixer tap with hose and wine (instead of the short length of copper pipe that I hope). The connector is a female form of the son of stainless steel (similar to that used to connect a hose washing machine dial-TAP) in touch. What equipment do I need to connect copper tube 15 mm from me in touch?
6 comments:
Take your hose to B & Q and try a few accessories. You know that your tube 15 mm, and therefore only need to a placement of 15 mm, the one side and an outer thread of the same size as the hose found in the other.
It is well designed to fit a standard 15mm valve. If it does not contact the manufacturer and ask him?
Plumbers
Plumbers
I am also afraid that if the necessary knowledge to have to solve this problem, you do not have the opportunity to establish a secure connection. You will probably have two connections, the other a warm and cold water - 15mm compression at one end and iron man at the other end. You also need washers or seals or PTFE tape, after the installation of faucet you have. Play safe and get a plumber. Do not bother asking anyone at B & Q, Homebase and Focus, the non-index.
Do you have valves in old age render them usable? If you can not buy 2 of them are compression fittings and welding of some accessories receive 1 / 2 inch borders and new valve has 3 / 8 inch fittings, valves are of this size,
Little advice if you have a digital camera, a photo and a part of the Home Depot is the creation of flexible and much easier to install, and if supply lines do not meet, you simply remove the power supply lines connected to equipment with his picture and as an adapter, to connect it to the size in touch, I recommend The Home Depot, because small business if I have the adapter that you will be much more difficult to sell than to saughter weld and move with the sound card much faster
Post a Comment